This time while upgrading the Pacemaker device it was a success. Its a strange combination because I got a Micro SD stuck in a SD card which is stuck in a Compact Flash card which is connected to the Pacemaker device with a tight Zif cable.
Its not so tight as when I had the 1.8inch SSD but the zif cable is still not in the best position it could be if it was shorter, as I noted on my original pacemaker device.
Next stop is to upgrade that battery. I’m thinking about a larger flat battery which can lay on top of the compact flash holder?
I have been travelling again; and when I travel I can’t help but get the Pacemaker device out. So with a recent bunch of travelling including to the Moon Festival and buying a tune with a woman I use to play Volleyball with (Sarah de Warren). I threw together this mix while on a delayed plane to Guernsey for a wedding over the bank holiday weekend.
Lots of Moon and Sun related tunes and a photo credit to edbrambley.
As always Enjoy!
Fading (extended mix) – Rodg X and Sarah de Warren
Moonlight party – Fonzerelli
Moon Shadow (Fictitious riceboy remix) – Mike Efex
Lost in moonshine infinity – Planisphere
Dark side of the Sun – Rory Gallagher
Dark side of the Moon (Marc Van Linden remix) – Ernesto Vs Bastian
Salvation (Album Re-vised mix) – M.I.K.E
Reborn – Ferry Corsten
Homeward – Ferry Corsten
Sunshine City – Slava V
The Wave 2.0 (extended mix) – Cosmic gate
Follow Me (Jerome Isma-Ae Extended remix) – Jam & Spoon
Sunrise – Marninx pres Ecco
Thanks to our excellent lab technician Elizabeth. I bought a 3.7v battery to replace the one in my 2nd pacemaker. I previously had replaced the 1.8 inch SSD with a SD card, so knew there was more room in the pacemaker case.
I had hoped to buy a very thin battery which I could slip under the SD card but I couldn’t find one with a higher capacity than 500mAh. Instead I looked for the highest capacity I could get which fit into the same battery space. I found a few 1100mAh batteries but then finally found one which was 1500mAh and the same voltage.
I unfortunately couldn’t didn’t quite get the right size, I was about 1-2mm’s off in height. The only way to make it fit was to remove the brackets which protected the old SSD/HD from the battery. As there was no drive anymore I decided its ok to remove them. With them gone, I could shift the battery over a bit and fit it in.
With some great soldering from Elizabeth, I was able to get everything back in the case and screw the whole thing together.
Looking forward to doing similar with my main pacemaker device, maybe?